Page 1 of 1

HTX Information Port

PostPosted: 24 September 2014, 08:20
by wmconlon
I notice that the Heat Exchanger Unit Operation allows me to add a Virtual Information Port, but I have never been succussful connecting an information stream to a Heat Exchanger.

Is there a trick to make this work?

Re: HTX Information Port

PostPosted: 24 September 2014, 11:40
by jasper
You can define virtual information ports for all unit operations, that are routed to input or output parameters.

You should be able to connect them without problems to an information stream. Perhaps in the case of specifically a heat exchanger, you experience the problem that the icon only has 4 connection points. Try removing the icon? (right click unit, icon, remove icon).

Re: HTX Information Port

PostPosted: 25 September 2014, 04:39
by wmconlon
Bingo!

Thanks.

Re: HTX Information Port

PostPosted: 25 September 2014, 07:18
by jasper
Good to hear. You can simply edit the icon and add more connection points.